Specification

High-quality adhesive and sealing compound for use in industry and the automotive sector.

Excellent resistance to chemicals

Can also be used in critical areas in which the seal comes into contact with various liquids

Outstanding resistance to engine oil and transmission oil, refrigerant and anti-freeze agent

Non-acidic hardening system

Non-corrosive, therefore has no negative impact on electronic components and on lambda probes

Sealant in compressed-air can

Easy to dispense without additional aids

The fine beads allow the product to be applied uniformly

Notice

When sealing e.g. oil pans and gearboxes it is vital that no sealant gets into the interior. For this reason we recommend to apply the sealant on a joining part surface. Join both parts and then carefully press by hand and lightly slide against each other. Afterwards separate the parts again and then remove the sealant that has gone inside. Join the components again within a max. of 5 minutes and tighten firmly. Before commissioning, observe the hardening time (depending on the sealant thickness).

The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. We do not assume any liability for a specific application result due to the large number of applications and storage and processing conditions. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Instructions

Optimum adhesion to dry, clean and dust-free surfaces. The old sealant must be removed in full from the surface.

Colour: Transparent
Contents: 200 ml
Chemical basis: Neutral crosslinked silicones,oxime-based
Smell/fragrance: Characteristic
Min./max. temperature resistance: -60 to 260 °C
Max. short-term temperature resistance: 300 °C
Range of applications: Sealing of accumulators
Sealing of halogen lamp
Sealing of vehicle body parts
Sealing of transformer
Density: 1.05 g/cm³
Min. skin-formation time: 5 min
Conditions for skin-formation time: at 23°C and 50% relative humidity
Full curing speed: 3 mm/d
Fully hardening/curing conditions: 23°C and 50% relative humidity
Shore A hardness: 15
Min. tensile strength: 2.2 N/mm²
Conditions for tensile strength: in accordance with ASTM D-412
Max. breaking elongation/conditions: 400 % / in accordance with DIN 53504
Heat conductance λ: 0.2 J/(m*s*K)
Heat conductance λ conditions: in accordance with ASTM D-2214/70
Coefficient of thermal expansion: 0.0002 1/K
Coefficient of thermal expansion conditions: in accordance with ASTM EB-31
Dielectric strength: 16 kV/mm
Dielectric strength conditions: in accordance with ASTM D-149
Relative permittivity: 2.8
Conditions for relative permittivity: 1 MHz, ASTM D-150
Loss factor: 0.002
Loss factor conditions: 1 MHz, ASTM D-150
Specific volume resistivity: 1000000000000000 Ohm/cm
Conditions for specific volume resistivity: in accordance with ASTM D-257

*All pictures shown are for illustration purposes only. The actual colours may vary from those shown depending on the device you are using to view the product or the angle of the item is photographed. Actual products may vary due to product enhancements or updates. The listing should be referred to for the description of the product, any questions should be asked prior to purchase.