Switch Fascia Dash Panel Insert Holden Colorado 2017

This replaces the existing fascia that is located in the central lower dash that has the 2 12v outlets and is compatible with all 13 models MY17 Holden Colorado’s from the base 2×4 models to the 4×4 Z71.

The fascia is a direct replacement injected molded ABS/PC panel, with zero modification to the existing surrounding console, enhancing the OEM look of the vehicle. It will accommodate 5 standard OEM style switches or 3 OEM style switches when the existing heater switches are utilized (Z71 model).

Standard OEM style switches used are the popular and readily available aftermarket Toyota switches Lightforce Range part # CBSWTY2 (top row) and CBSWTY (bottom row).

The Lightforce dual switch CBSWTY2D is also compatible allowing for up to 6 individual switched outputs from the top row locations.

A single switch (CBSWTY2) and two switch blanks are provided with the fascia; the blanks have been designed to accommodate the REDARC® Tow-ProTM remote brake controller. On the back of the blanks will be two corresponding indents to aid in drilling the 2 required holes, extra blanks are available.

For models without heater seat switches the two lower locations will require additional switches (not included). No switch blanks are available for the 2 lower switch locations.

Fascia is a sliver / grey finish similar to the OEM colour, installation takes approximately 20 minutes and only requires a medium Phillips, blade screwdriver and trim removal tool (recommended) as the surrounding console simply pulls off.

The new switch fascia relocates in all the exact same mounting points as the original OEM so exact fitment is retained, no additional fixtures or adhesives are required.

The 2 existing 12v outlets and plastic retaining clips will need to be removed from the original fascia and refitted into the new fascia. In addition, for the Z71 model the heater switches are also reused.

Kit Contents

• 1 x Switch Fascia for 2017 Holden Colorado
• 1 x Single Switch
• 2 x Switch blanks
• 1 x Instructions

Optional Accessories

• Dual 2.1 amp USB Switch (4.2A in total) outputs that are fully regulated and surge protected. Independent illumination that is fully dimmable via existing dash light circuit, separate from the main input power, so illumination is not always on; a unique feature of our product. All cables are over 1.5 metres long, USB power input (red wire) in is fitted with a mini fuse tap for direct fitment to the fuse box. Negative cable (black wire) is pre-terminated with a ring terminal and independent LED illumination (blue wire) for connection to existing dash light circuit.
• RJ45 Switch pass through connector allows for a remote microphone fitted with an RJ45 connector to be connected directly into a switch blank location on the Lightforce fascia #CBRJ45FP
• Dual switch with a single input activates independently top and bottom switches, so if you have a series of dual switches they will need to be grouped into lighting (active with Hi beam) or active with a constant power or ACC on power
• Single position switches available #CBSWTY2 (top row) #CBSWTY (bottom row not included).
• RJ45 cable 1200mm (for TowPro) – CBRJ45
• Switch blank suitable for mounting a REDARC® Tow-ProTM remote brake controller (2 blanks are included with the fascia)
• Lightforce dual switch CBSWTY2D

Australian Design patent pending.