x1 Stainless Steel Anderson Plug Surface Mount Cover INC x2 3pin & x2 Grey 50 Amp Plugs.

(x2 3pin & x2 Grey 50 Amp Andersons Included)

Australian made stainless steel surface mounting cover, this mount is a neat simple solution for mounting a x1 3pin & x1 50 Amp Anderson Plug on any flat Surface of your Canopy, head board, Ute tray, camper, caravan or boat.

THE NITTY
GRITTY.

– 1x 304 Stainless Stainless Steel Finish (Dimensions: 113mm x 97mm x 18mm)

– 2 x 3 Pin 50 Amp Anderson plugs

– 2 x GREY 50 Amp Genuine Anderson Plugs

– 6 x Mounting Bolts

– 6 x Nuts & Washers

Installation guide.

– Assess where to mount the cover plate and ensure there is sufficient room behind for mounting & wiring.

– Mark the 6x holes. These points will be the bolt holes. Predrill 4mm holes

– Mark out where the wiring will go through the surface behind the Anderson and drill hole to suit

– Pull Wiring through the hole, Pre-wire the Anderson plug and fit terminals.

– Using the bolts fit the Anderson plug between the cover plate and the surface, the bolts are a neat fit and slide straight through the plug.

Check out our store to see other combinations available. 

PLEASE NOTE: Item INCLUDES the Anderson plugs. This listing is for the stainless steel cover plate, fasteners & a Pair 3 Pin & a Pair of GREY 50 Amp Anderson Plugs, if you want this with out the Andersons or in a Powder Coated Black Finish, please see our other listing in our store.

*All pictures shown are for illustration purposes only. The actual colours may vary from those shown depending on the device you are using to view the product or the angle of the item is photographed. Actual products may vary due to product enhancements or updates. The listing should be referred to for the description of the product, any questions should be asked prior to purchase.